Hot lime and haired lime plaster
Quicklime slaked on site and mixed hot, haired lime base coats and lime putty finishes for old brick and stone walls in Cheshire and Derbyshire, with limewash-ready surfaces.
The oldest lime plasters are made on the job. Quicklime is slaked with water on site, and the mortar is mixed while it is still hot. Hair, or in some places fibre, goes into the base coats to hold them together. It is more work than a bagged mix and is chosen for old walls where it fits the building.
Hot lime
Quicklime gives off heat and is caustic when it is slaked, so it is handled with care. Mixing hot improves workability and helps the binder stick to the aggregate, and it suits cold working conditions. On a house in Belper it was used for a harled scud coat applied while the lime was still hot, which regulates the wall's suction before the later coats.
Where it has been used
- A single-skin brick wall in an 1800s house in Sandbach, hot lime with cow dung to stop soot seeping through and synthetic fibres to reduce shrinkage cracking, finished with lime putty and kiln-dried sand.
- A hot lime base around a window and shaped lime plaster framing a steel lintel in a Glossop home.
- Alcoves either side of a chimney breast in Bollington, with slaked lime putty and pit sand as a base coat that limits shrinkage, keyed with a figure-of-eight devil float.
- Walls in Belper, slaked and mixed on site and then floated and skimmed in lime.
Hair, putty and limewash
Hair is what holds well-made lime plaster together. In Buxton, plaster that came away from an external wall was collected, crushed and remixed with fresh lime putty and horse hair for a like-for-like repair, which gave a decent hydraulic set. On two jobs spare lime putty was left with the owner for limewashing later, the breathable finish that suits lime.