Ceiling overboarding and repairs
Overboarding and skimming cracked, uneven or damaged ceilings, covering textured ceilings, and repairing leak damage in homes across Macclesfield, Cheshire and Derbyshire.
Overboarding means fixing new plasterboard over an existing ceiling and skimming it. It suits ceilings that are uneven, cracked or at risk of cracking, and it leaves the old surface in place, which is gentler on an older building than taking it all down. The new board gives a flat, stable base for a gypsum skim, or for insulating lime plaster.
What it has been used for
- Overboarding existing lath and plaster ceilings in a stone cottage rather than removing them, before insulating and skimming.
- Overboarding and skimming in Belper, to give a fresh, even surface where the existing ceilings were uneven or at risk of cracking.
- A Buxton job where a solid plaster cornice was carefully removed, then ceilings overboarded in the main room and wardrobes and skimmed with gypsum.
- Ceilings in poor shape in Congleton, repaired with plasterboard and skimmed in gypsum, a practical answer where lath is patchy or damaged.
- A Glossop ceiling with an Artex finish covered with new plasterboard, with a ceiling rose fitted afterwards.
- A ceiling in Bollington damaged by an earlier leak, repaired and overboarded.
- A vaulted bathroom ceiling in Sandbach, overboarded with insulation to keep heat in and reduce condensation.
Textured coatings and leaks
Some older textured coatings contain asbestos. A textured ceiling should not be sanded, scraped or drilled until it has been tested, and if asbestos is found the next step is a matter for a licensed specialist, not a quick fix. Fix the cause of a leak first: board and plaster over a wet ceiling will fail again.
Detaching ceilings
Where old plaster is coming away, the safe move is to have it looked at. If it is lime on lath the fix may be a repair to the lath and nibs rather than a new ceiling: see lath-and-plaster repair. Floors and timber are protected before work starts.